Write the chemical formula for the following ionic compound nickel (III) sulfate 

Answer: Global warming causes sea-level rise as oceans expand, and makes storm patterns more energetic. Consequently it will affect most of the world's coastlines through inundation and increased erosion.

Explanation:

Answer:

The strongest intermolecular force in sulfur dioxide is dipole-dipole forces.

Explanation:

The interparticle force in [tex]SO_{2}[/tex] (sulfur dioxide) is the dipole-dipole interaction.

Dipole-dipole interaction is a type of intermolecular force that occurs between polar molecules. Polar molecules have a permanent dipole moment, which means they have a partial positive charge on one end and a partial negative charge on the other end. This creates an electrostatic attraction between the partial charges of neighboring molecules. The stronger the dipole moment of a molecule, the stronger its dipole-dipole interaction will be with other polar molecules.

Dipole-dipole interactions are responsible for a variety of physical properties of substances, including their boiling and melting points. Substances with strong dipole-dipole interactions tend to have higher boiling and melting points than substances with weaker interactions. In addition, the strength of dipole-dipole interactions can affect solubility, as polar substances tend to dissolve better in other polar substances due to their ability to form dipole-dipole interactions.

Learn more about dipole-dipole interaction, here:

https://brainly.com/question/30510859

#SPJ2

Answer:

moles = 36/180 = 0.2 moles

molarity = 0.2/2 = 0.1 mol/dm3

Answer:

SO2

Explanation:

that's my answer

Sana mKatolong

Answer:

WHAAAAAAAAAAAAAAAAAAAAT  

Explanation:

Answer:

Artificial selection, also called "selective breeding” is where humans select for desirable traits in agricultural products or animals, rather than leaving the species.

1. If the surface area of liquid is large then evaporation will be

A. small

B. large

C. moderate

D. slow

B. Large

Evaporation increases with increasing surface area. This is because the greater the surface area (exposed to the air), the more molecules escape into the air.

More surface area = Higher rate of evaporation.

Answer: B

Explanation:

I. Rusting is a chemical reaction which is oxidation of iron.

II. Boiling water is a physical change. There is no chemical change between H2O molecules. It only shifts to the gas state from the liquid state.

III. When egg is cooked proteins are denaturated so it changes interactions between molecules.

IV. Melting is also just a phase change like boiling.

Answer:

5. 0.02 seconds

6. (a) 0.0167 seconds

(b) Period in Lebanon is 0.02 seconds and in the U.S 0.0167 seconds. That means that the U.S. has the faster period.

Explanation:

Answer:

-1.76202

Explanation: Because the operation is subtraction, you would count the number of digits after the decimal point. Then you would perform the operation and round your answer to the SMALLER number of digits after the decimal point.

Answer:

50.00-mL volumetric flask and diluted to the mark with water. What is the molarity of the new solution? 12. 30.00 mL of water is added to 20.00 mL of 0.0500

Explanation:

Hope This helps

Have a great day

~Zero

Answer:

Substances can change phase—often because of a temperature change. At low temperatures, most substances are solid; as the temperature increases, they become liquid; at higher temperatures still, they become gaseous.

The process of a solid becoming a liquid is called melting. (an older term that you may see sometimes is fusion). The opposite process, a liquid becoming a solid, is called solidification. For any pure substance, the temperature at which melting occurs—known as the melting point—is a characteristic of that substance. It requires energy for a solid to melt into a liquid. Every pure substance has a certain amount of energy it needs to change from a solid to a liquid. This amount is called the enthalpy of fusion (or heat of fusion) of the substance, represented as ΔHfus. Some ΔHfus values are listed in Table 10.2 “Enthalpies of Fusion for Various Substances”; it is assumed that these values are for the melting point of the substance. Note that the unit of ΔHfus is kilojoules per mole, so we need to know the quantity of material to know how much energy is involved. The ΔHfus is always tabulated as a positive number. However, it can be used for both the melting and the solidification processes as long as you keep in mind that melting is always endothermic (so ΔH will be positive), while solidification is always exothermic (so ΔH will be negative).

The process of fertilization occurs externally in frogs.

A full growth of frog occurs when it passes through five stages of its life cycle. During a frog's metamorphosis, an egg will hatch and a tadpole appear in which the back legs emerge first, then front legs, and finally it become a full grown adult frog.

A frog's eggs are found in water because they do not have a hard protective shell like birds and reptiles. The frog's eggs are covered with a glycoprotein, which helps to keep the eggs moist so that's why the frog lays its eggs in water in order to prevent them from drying.

In most species of frogs, fertilization occurs externally. The male frog grabs the female's back and fertilizes the eggs as the female frog releases the eggs. Those eggs which receives the sperm will fertilized so we can conclude that the process of fertilization occurs externally in frogs.

Learn more about growth here: https://brainly.com/question/25630111

Learn more: https://brainly.com/question/26032527

This question is providing the masses of carbon dioxide and oxygen gases at 10.0 atm as 66 g and 16 g respectively, and is asking for the partial pressure of the former which turns out to be 7.50 atm after doing the math.

Thus, we can start solving this problem with the Dalton's law approach, in order to make a relationship for the total pressure, partial pressure and mole fraction, which means we must first determine the mole fraction of carbon dioxide gas in the mixture as shown below:

[tex]x_{CO_2}=\frac{n_{CO_2}}{n_{CO_2}+n_{O_2}}[/tex]

Next, we calculate the moles of both gases by dividing the grams over the molar masses:

[tex]n_{CO_2}=\frac{66g}{44.01g/mol} =1.50mol\\\\n_{O_2}=\frac{16g}{32g/mol} =0.5mol[/tex]

Then, the mole fraction of carbon dioxide as the required one by plugging in the previously calculated moles:

[tex]x_{CO_2}=\frac{1.5}{1.5+0.5}=0.75[/tex]

Finally, we use the definition of the Dalton's law to calculate the partial pressure of carbon dioxide gas in the binary mixture:

[tex]P_{CO_2}=x_{CO_2}P\\\\P_{CO_2}=0.75*10.0atm\\\\P_{CO_2}=7.50 atm[/tex]

Learn more:

(Dalton's law) https://brainly.com/question/14119417

Example #1 write the chemical formula for Calcium Oxide

Step 1

-Find the Atomic symbol of the metal and non-metal on the periodic table

CaO

Step 2

Find the charges for Calcium and Oxygen

which are Ca 2+ and O 2-

Step 3

Balance out the charges

They are already balanced out

Here´s the chemical formula for Calcium Oxide

CaO

Example 2 write the chemical formula for Aluminum Oxide

Step 1

-Find the Atomic symbol of the metal and non-metal on the periodic table

A

l

O

Step 2

Find the charges for Aluminum and Oxygen

Which are Al 3+ and O 2-

Step 3

Balance out the charges

You need 2 Aluminum and 3 Oxygen to balance the charges

Al 3+ O 2-

Al 3+ O 2-

= 6 + O 2-

= 6-

Step 4

If you need more then one element to balance out the charges you identify that by using subscripts

Heres your chemical formula for Aluminum Oxide

[tex]Al_{2} O_{3}[/tex]

Answer:

vigorous

Explanation:

As you go down group one of the periodic table, the reactions become and more vigorous.

To solve such this we must know the concept of acid and base reaction. Therefore, the concentration of acid decides the concentration of hydrogen gas evolved.

Chemical reaction is a process in which two or more than two molecules collide in right orientation and energy to form a new chemical compound. The mass of the overall reaction should be conserved. There are so many types of chemical reaction reaction like combination reaction, double displacement reaction.

When creating mixture the amount of hydrogen gas is directly related to the concentration of the acid mixture, the higher the concentration level The more hydrogen gas would be produced.

Therefore, the concentration of acid decides the concentration of hydrogen gas evolved.

Learn more about the chemical reactions, here:

https://brainly.com/question/3461108

#SPJ2

Answer: Cell wall

Explanation: Cell wall is a unique structure found only in some specific organisms like plants, bacteria, fungi etc. The cell wall in plants is predominantly made up of a polysaccharide called CELLULOSE. This carbohydrate confers upon the cell "rigidity".

The cell wall is an additive material including the cell membrane that coats the external part of the cell of plants, hence, it gives plant cells their characteristic shape. The cell wall contributes to the overall flexible but rigid shape of the plant cell, protecting the cell against physical or chemical stresses.

Answer:

A horizontal row in the periodic table, which signifies the totoal number of electron shells in an element's atom.

Explanation:

Hope this helpss)):

Answer:

compound

Explanation:

compound = A substance consisting of atoms or ions of two or more different elements in definite proportions joined by chemical bonds into a molecule.

Answer:

1.514 moles

Explanation:

For this problem you want to use dimensional analysis and cancel out your molecules of sugar and be left with moles of sugar. We know that 1 mole (of anything) = 6.022 x 10 ^ 23 molecules, so we should use that conversion to help us. Start with 9.12 x 10 ^23 molecules and divide by 6.022 x 10 ^ 23 molecules, and you will be left with moles.

Hope this helps!

The periodic table is composed of metals and nonmetals arranged in groups and periods.

The periodic table is an arrangement of elements in groups and periods based on their properties. The properties of elements repeat at regular intervals hence the term, "periodic".

The answers to the questions are;

7)  Element Families on the Periodic Table have similar properties. There are 18 families.

8) Alkali Metals are good conductors of heat and electricity.

9) There are a total of 38 elements that are grouped as Transition Metals.

10)  As opposed to metals, non-metals can be very opaque. They have no metallic luster and do not reflect light.

11)  All Lanthanide Series elements occur naturally except for promethium.

12)  All Actinide Series elements are radioactive and most are synthetic.

Learn more about the periodic table: https://brainly.com/question/24719506  

Answer:

Preserving soil, water and energy resources has enabled modern farming to grow food sustainably on the same land for more than 100 years. ... Modern, conventional agriculture has key sustainability benefits in terms of land use, reduced soil erosion and water protection.

Explanation:

hope it helps you

Answer:

a subshell is a subdivision of electron shells that are separated by electron orbitals.

Explanation:

(subshells are labeled s,p,d, and f in an electron configuration)

The two ions present in the solution are:

1. Sodium ion, Na⁺

2. Hydroxide ion, OH¯

The correct answer to the question is the 3rd option. The sodium ion is positive, and the hydroxide ion is negative.

Ions are atoms or group of atoms which possess an electric charge.

Aqueous Sodium hydroxide, NaOH contains sodium ion and hydroxide ion.

The sodium ion is positive while the hydroxide ion is negative as illustrated below:

NaOH(aq) —> Na⁺(aq) + OH¯(aq)

From the illustration above, we can conclude that the correct answer to the question is the 3rd option. The sodium ion is positive, and the hydroxide ion is negative.

Please see attached photo for further details

Learn more: https://brainly.com/question/4414335

Answer:

Volume occupied is approx.  

38 ⋅ ML

Explanation:

Density  ρ = Mass  Volume  And thus  Volume  = Mass  ρ = 1.592 ⋅ l b × 454 ⋅ g ⋅ l b − 1 19.3 ⋅ g ⋅ m L − 1   =   ? ? ⋅ m L

Answer:

the force that you applied caused the notebook to move.the force applied on the notebook by the table causes it to stop moving. this is because after sometime the book uses up the force and later the force you applied is less than that of the force by the table.