Answer:
a; increasing fraction
Explanation:
Please help ASAP 100 points points help I will mark you as brainlister
this is lithium ion with a +1 charge
Ou are subliming camphor and you note that pure camphor is condensing nicely on the cold finger. You check on the process several minutes later and you see that the amount of camphor on the cold finger has not changed appreciably since the last time you looked at it. However, there is still plenty of impure camphor left at the bottom of the flask. What do you suppose is the reason and what do you need to do.
Answer:
The reaction is endothermic
Increase temperature of the flask
Explanation:
Sublimation is a phenomenon in which a substance changes directly from solid to gas,without passing through the liquid phase.
Camphor is a sublime substance. The sublimation of camphor is an endothermic reaction. This implies that energy is absorbed in the process.
For an endothermic reaction, the equilibrium position is shifted towards the right hand side by increasing the temperature of the system. Hence, if the flask is heated, more camphor will condense within a shorter time interval.
Why are small quantities of chlorofluorocarbons so harmful to the ozone layer? a. The chlorofluorocarbons act like ultraviolet radiation causing large amount of ozone to be produced. b. The chlorine from the chlorofluorocarbons reacts with free molecules of oxygen causing a stop in ozone production. c. Free oxygen atoms can replace the chlorine in chlorine monoxide, releasing a free atom of chlorine which can then recombine with an oxygen atom in ozone, destroying more ozone. d. Chlorofluorocarbons absorb ultraviolet radiation, preventing the formation of ozone.
Answer:
Why are small quantities of chlorofluorocarbons so harmful to the ozone layer? Free oxygen atoms can replace the chlorine in chlorine monoxide, releasing a free atom of chlorine which can then recombine with an oxygen atom in ozone, destroying more ozone.
Explanation:
The statement for small quantities of chlorofluorocarbons so harmful to the ozone layer is "Free oxygen atoms can replace the chlorine in chlorine monoxide, releasing a free atom of chlorine which can then recombine with an oxygen atom in ozone, destroying more ozone."
What is ozone layer?The ozone layer is a thin layer of air in the Earth's atmosphere that absorbs nearly all of the sun's damaging UV radiation.
What is CFCs?CFCs (chlorofluorocarbons) are harmless and nonflammable compounds made up of carbon, chlorine, and fluorine atoms.
The earth's protective ozone layer is destroyed by chlorofluorocarbons (CFCs), hydrochlorofluorocarbons (HCFCs), and halons, which shield the earth from damaging ultraviolet (UV-B) rays released by the sun. CFCs and HCFCs also warm the earth's lower atmosphere, causing global climate change.
When some substances are exposed to high UV radiation in the stratosphere, they emit chlorine or bromine. Ozone-depleting chemicals are compounds that contribute to ozone depletion (ODS). Chlorofluorocarbons (CFCs), hydrochlorofluorocarbons (HCFCs), carbon tetrachloride, and methyl chloroform are examples of ODS that produce chlorine. Halons and methyl bromide are two ODS that emit bromine.
Because there isn't much ozone in the atmosphere, what little there is is critical for protecting the Earth's surface from excessive UV light from the Sun. It turns out that it reacts with chlorine, which means that chlorine effectively eliminates ozone.
When the chlorine in CFCs combines with ultraviolet light, it releases chlorine, which then reacts with ozone, reducing the protection humans get from ultraviolet light, allowing more CFCs to release chlorine, and so on. Multiple ozone molecules will interact with one free chlorine atom, which is free because UV light has hit the CFC molecule. As a result, the damage it can cause is likely to be significantly more than you might imagine.
Hence the correct option is c.
Learn more about ozone layer and CFCs here
https://brainly.com/question/14330630
#SPJ2
Please can I have help on these two questions I’ll be very grateful!!!!!!
Answer:
-1 IS THE CHARGE OF ELECTRON AS THEY ARE NEGATIVE
MARK ME AS BRAINLIEST IF U FOUND IT HELPFUL
helppppppppppppp plzzzzzzzz Identify each structure based on its label.
Compound A is a
amine.
Compound B is a
amine.
Compound C is a
amine.
Compound D is
.
Answer:
kldja
Explanation:
A.) primary
B.) tertiary
C.) secondary
D.) ammonia
edge2020
i need help please!
asap
Answer:
Earth is pulling up on the book with a force of 4n i think
Explanation:
What is Aerosol,sol and gel
What are the reactants of photosynthesis?
Answer:
The photosynthesis chemical equation states that the reactants (carbon dioxide, water and sunlight), yield two products, glucose and oxygen gas. The single chemical equation represents the overall process of photosynthesis.
Explanation:
5. Aidan is on a carnping trip with his family. As the temperature decreases
Aidan suggests building a campfire. Which of the following explains why
heat moves from the campfire to the people sitting around it? *
Answer:
Because heat flows from warmer objects to cooler objects
Explanation:
Why is the nitrogen cycle considered a closed system?
Answer:
because nitrogen is fixed by bacteria and assimilated by plants
Explanation:
Answer:
It is a considered a closed system because nitrogen is fixed by bacteria and is taken in by plants.
Explanation:
Which of these statements describes a chemical property?
Answer:
it rusts when exposed to air
Answer:
A
Explanation:
HELP ASAPP JUST TELL ME WHAT TO PUT IN THE MISSING SPACES words(cell,microorganisms,micrometer,microscopic,molecule)
Answer:
microorganisms, molecule, microscopic, cell, micrometer
Explanation:
If you find my answer helpful
Pls consider marking it as Brainliest! It would mean a lot!
Help pleaI’ll give brainliest
Which element has the
greatest number of valence electrons available for bonding?
O selenium
Oboron
O calcium
O chlorine
What’s this called please help
Answer:
the answer is a linear
Explanation:
heres a graph different ones at this link
8. Describe how crystals of copper sulphate are prepared.
Answer:
Take a cupful of water in a beaker and add a few drops of dilute sulphuric acid. Heat the water. When it starts boiling, add copper sulphate powder slowly while stirring continuously. ... Crystals of copper sulphate will be seen at the bottom of the beaker.
Hope it helps
An object with a mass of 1.2 g takes up a space of 2.4 mL. What is it's density?
Answer:
The answer is 0.5 g/mLExplanation:
The density of a substance can be found by using the formula
[tex]density = \frac{mass}{volume} \\ [/tex]
From the question we have
[tex]density = \frac{1.2}{2.4} \\ [/tex]
We have the final answer as
0.5 g/mL.Hope this helps you
A physical change is easier / more difficult to reverse than a chemical change.
Answer:
the answer is that a physical change is easier to reverse then a chemical change.
Explanation: In order for a physical change to take place it's easier to just undo what happened then if it was a chemical change because in order for very few chemical changes to reverse to it's original substance you would need another chemical change.
True or false
Each family represents the number of energy levels present in an atom of the element.
Answer:
true because of the elements
what is the journey around the sun by earth called, and how long does it take?
Answer:
Its called ecliptic and it takes 365 days
Explanation:
Answer:
The journey around the Sun by Earth is called a revolution, it takes 365-and-a-quarter-days.
Explanation:
Which of the following is NOT an example of a chemical change? *
O Corrosion
O Grinding
O Combustion
O Rust
Molecules in a liquid are:
closer together than in a gas
moving more quickly than in a solid
moving more slowly than in a gas
all of the above
Please help!!!
Answer:
all of the above
Explanation:
What are natural resources
Answer:
resources that come from the ground or eath naturally which also means that those minerals like coal take hundreds of years to be created
500 gram of flour added with 1L of water anong lalagyan o bottle magkakasya ang 500gram of flour ang 1L of water
Answer:
it will become a bread
Explanation:
net Mass will become 1.5 liter
Describe the specific steps a scientist would take to solve a particular problem
Answer:
scientific method
Explanation:
- make an observation
- ask a question
- form a hypothesis
- make a prediction based on the hypothesis
- test the prediction
- iterate: use the results to make new hypotheses or predictions
how many atoms are in CaCI2
Answer:
4
Explanation:
bc Ca is 1 C is one L is two
The transition metals (with the exception of Zn, Cd and Hg) are very much hard and have low volatility. Why Zn ,Cd and Hg has low melting points. (a) These have all their electrons paired. (b) These have maximum number of unpaired electrons. (c) These have very strong metallic bonding. (d) These have more metal-metal bonding.
Answer:
Zn ,Cd and Hg has low melting points because - These have all their electrons paired.
Explanation:
These have all their electrons paired -: All the electrons in the d-subshell are combined with Zn , Cd and Hg. The metallic bonds present in them are, therefore, weak. This is why they have low points of melting and bolting. therefore , this statement is true. These have maximum number of unpaired electrons. Since , these transition metals have all electrons paired , so this statement is incorrect.These have very strong metallic bonding -: Zn, Cd and Hg d-orbital are completely filled. They have poor metallic bonding and less compact packing due to their fully filled d-orbitals, so all of them are volatile in nature. Therefore, this statement is also not valid .These have more metal-metal bonding. -: Since , their metallic bond is weak , so this statement is not true .Hence , the correct option is A (These have all their electrons paired).
An unknown substance has a volume of 2 cm3 and a mass of 38.6 grams.
What is the density of the sample?
Answer:
The answer is 19.3 g/cm³Explanation:
The density of a substance can be found by using the formula
[tex]density = \frac{mass}{volume} \\ [/tex]
From the question we have
[tex]density = \frac{38.6}{2} \\ [/tex]
We have the final answer as
19.3 g/cm³Hope this helps you
Which is the IUPAC name for NO?
nitric oxide
binitrogen oxide
dinitrogen dioxide
nitrogen monoxide
The IUPAC name for NO is nitric oxide. The correct option is A.
What is IUPAC naming?The International Union of Pure and Applied Chemistry (IUPAC) is a global organization that represents chemistry as well as related sciences and technologies.
The chemical compound's identity is represented by its common and IUPAC names, which differ from one another. Every chemical compound has multiple names.
Complete the following step-by-step response: The IUPAC nomenclature is a standardized name given to organic compounds in accordance with official naming rules.
Nitric oxide, also known as NO, is a colorless gas. It is one of the most important nitrogen oxides.
Nitric oxide is a free radical, which means it has an unpaired electron, which is sometimes represented in its chemical formula by a dot.
Thus, the correct option is A.
For more details regarding IUPAC, visit:
https://brainly.com/question/16631447
#SPJ6
Answer:
D: Nitrogen Monoxide
Explanation:
There's one Nitrogen atom and one Oxygen atom
Is this actually right
Answer:
what?????????i don't see a question
Answer:
Yes
Explanation:
WHOEVER ANSWERS THIS QUESTION FIRST WILL GET BRAINLIEST!!
PLEASE HURRY!!!
Select 5 elements that form ions in an isoelectronic series with the noble gas Argon. Support your claim with evidence and scientific reasoning.
Answer:
Explanation: