Gamma rays are given out from the
of radioactive atoms. What one word completes the sentence??

Answer:

letterman is shooting the kids

We use insulators to avoid being electrocuted. electricians use rubber gloves to avoid shock. Cables are insolated with rubber so you can hold them without getting shocked even if it is plugged in.

Answer:

a. The student's mistake was that the student did not swing the pendulum and start the watch at the same time.

b. 1.2 s per swing.

c. The likely effect of her reaction time is that they will should subtract two seconds off the time.

Explanation:

The pupil made the error of not simultaneously starting the watch and swinging the pendulum.

Pendulum is defined as a body that is suspended from a fixed point and moves back and forth while being pulled by gravity. The pendulum is used to gauge the gravitational pull because the force of gravity causes it to swing back toward its average position. A pendulum's time period can be used to tell the time because it is constant.

The swing of the pendulum is 1.2 sec. per swing. They should take two seconds off the timing due to her presumably slow reaction time. A pendulum's total time should be divided by the quantity of oscillations in order to determine its time period. When compared to a pendulum with a shorter string, the one back and forth cycle of a longer-stringed pendulum requires more time to complete.

Thus, the pupil made the error of not simultaneously starting the watch and swinging the pendulum.

To learn more about pupil, refer to the link below:

https://brainly.com/question/27874242

#SPJ2

Explanation:

v = u + at

25 = 75 + a * 5

25 = 75 + 5 a

a = 25 - 75/5

a = -50/5

a = -10m/sec^2

please mark me as a brainelist

Answer:

The required velocity of runner is 4m/s.

Answer:

Range of projectile, R

For projection above ground surface, the range of the angle of projection with respect to horizontal direction, θ, is 0° ≤ θ ≤ 90° and the corresponding range of 2θ is 0° ≤ 2θ ≤ 180°.S

hope you're looking for this.

Answer:

the density is 0.301 :)

Answer:

d = 120 [m]

Explanation:

In order to solve this problem, we must use the theorem of work and energy conservation. Where the energy in the final state (when the skater stops) is equal to the sum of the mechanical energy in the initial state plus the work done on the skater in the initial state.

The mechanical energy is equal to the sum of the potential energy plus the kinetic energy.  As the track is horizontal there is no unevenness, in this way, there is no potential energy.

E₁ + W₁₋₂ = E₂

where:

E₁  = mechanical energy in the initial state [J] (units of Joules)

W₁₋₂ = work done between the states 1 and 2 [J]

E₂  = mechanical energy in the final state = 0

E₁ = Ek = kinetic energy [J]

E₁ = 0.5*m*v²

where:

m = mass = 60 [kg]

v = initial velocity = 12 [m/s]

Now, the work done is given by the product of the friction force by the distance. In this case, the work is negative because the friction force is acting in opposite direction to the movement of the skater.

W₁₋₂ = -f*d

where:

f = friction force = 36 [N]

d = distance [m]

Now we have:

0.5*m*v² - (f*d) = 0

0.5*60*(12)² - (36*d) = 0

4320 = 36*d

d = 120 [m]

Answer:

Black holes are some of the strangest and most fascinating objects in outer space. They're extremely dense, with such strong gravitational attraction that even light cannot escape their grasp if it comes near enough. so when in books, movies, songs, video games, comics, paintings, etc you can imagine the impossible. as in escaping a black hole

Explanation:

Answer:

its D

Explanation:

i took the assignment, its D

Answer:

1) 2197.44 J

2) 0 J

3) 2197.44 J = Constant

4) 2197.44 J

5) Approximately 8.86 m/s

Explanation:

The given parameters are;

The mass of the diver, m = 56 kg

The height of the cliff, h = 4.0 m

The speed with which the diver is moving, vₓ = 8.0 m/s

The gravitational potential energy = Mass, m × Height of the cliff, h × Acceleration due to gravity, g

1) Her gravitational potential energy = 56 × 4.0 × 9.81 = 2197.44 J

2) The kinetic energy = 1/2·m·u²

Where;

u = Her initial velocity = 0 when she just leaves the cliff

Therefore;

Her kinetic energy when she just leaves the cliff = 1/2 × 56 × 0² = 0 J

3) The total mechanical energy = Kinetic energy + Potential energy

The total mechanical energy is constant

Her total mechanical energy relative to the water surface when she leaves the cliff = Her gravitational potential energy = 2197.44 J = Constant

4) Her total mechanical energy relative to the water surface just before she enters the water = 2197.44 J

5) The speed with which she enters the water, v, is given from, v² = u² + 2·g·h

Where;

u = The initial velocity at the top of the cliff before she jumps= 0 m/s

∴ v² = 0² + 2 × 9.81 × 4 = 78.48

v = √78.48 ≈ 8.86 m/s

The speed with which she enters the water, v ≈ 8.86 m/s

1) Her gravitational potential energy relative to the water surface when she leaves the cliff is; GPE(leaves cliff) = 2195.2 J

2) Her kinetic energy when she leaves the cliff is; KE = 0J

3) Her total mechanical energy relative to the water surface when she leaves the cliff is; ME_total = 2195.2 J

4) Her total mechanical energy relative to the water surface just before she enters the water is; ME_total = 2195.2 J

5) The speed at which she enters the water is; v = 8.85 m/s

We are given;

Mass of the diver; m = 56 kg

Height of the cliff; h = 4 m

Speed at which she is moving; vₓ = 8 m/s

1) Formula for gravitational potential energy is;

GPE = mgh

where;

m is mass

g is acceleration due to gravity

h is height

Thus;

GPE = 56 × 4 × 9.8

GPE(leaves cliff) = 2195.2 J

2) The formula for kinetic energy when she leaves the cliff is;

KE = ¹/₂mu²

Where;

m is mass

u = initial velocity = 0 m/s

Thus;

KE = ¹/₂ × 56 × 0²

KE(leaves cliff) = 0 J

3) The total mechanical energy relative to the water surface when she leaves the cliffis;

ME_total = GPE(leaves cliff) + KE(leaves cliff)

Thus;

ME_total = 2195.2 + 0

ME_total = 2195.2 J  

4) Her total mechanical energy relative to the water surface just before she enters the water is same as that when she leaves the cliff = 2195.2 J

5) The speed with which she enters the water, v, is gotten from newtons third equation of motion;

v² = u² + 2gh

Thus;

v² = 0² + (2 × 9.8 × 4)

v² = 78.4

v = √78.4

v = 8.85 m/s

Read more at; https://brainly.com/question/25708521

Answer:

Explanation:

Angle of refraction is the angle made by refracted ray with the normal at the point of incidence . In this figure , refracted ray has been shown by line having arrow-head . Normal has been shown by broken line .

We observe that in figure D , angle made by refracted ray with normal is greatest . So figure D is the answer.

The  image where the angle of refraction is the greatest is the image D

The angle of refraction is the angle that the refracted ray made with the x-axis.

The higher the angle between the refracted ray and the x-axis, the higher the angle of refraction and vice versa.

From the given diagram, we can see that the  image where the angle of refraction is the greatest is the image D

Learn more on angle of refraction here: https://brainly.com/question/15838784

Answer:

A................

Explanation:

Hope this helps you

A. increase it's current and increase it's voltage

Explanation:

Answer: a piece of iron near a magnet

Explanation:

Answer:

Eh = 21 [J]

Removed as heat.

Explanation:

This is a case of energy conservation, we have to take into account the energies that go in and out of the system. In this case, 135 [J] of energy are entered in the form of work of the compressor to the chamber where the refrigerant is compressed, now of these 135 [J] 114 [J] were used as internal energy, this internal energy is used to increase the pressure and temperature of the refrigerant.

In this way the rest of the energy of the 135 [J] was lost in the form of heat to determine this loss of energy, we simply perform the arithmetic subtraction.

Eh = 135 - 114 = 21 [J]

Eh = 21 [J]

‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎‎1500 kpm

Answer:

tura paulo

Explanation:

sry if im wrong ;)

Answer:

12m/s2

Explanation:

:D (just a smiley, not answer d)

Answer:

Health relates to science because

in science you study, research, and knowledge in this case, health science, which helps you under stand more about how humans and animals function. And Physical education relates to science because , you study the way of human movement, think of push-ups as a example.

I hope I helped U ´꓃ ` U

Answer:

8000cm³/hr

Explanation:

Given parameters:

Volume of the liquid draining off per hour   = 8000cm³

Time taken to drain off  = 1hr

Unknown:

Flow rate  = ?

Solution:

Flow rate is the volume of fluid that passes per unit of time.

 Flow rate  = [tex]\frac{volume of fluid}{time taken}[/tex]  

 Flow rate  = [tex]\frac{8000cm^{3} }{1hr}[/tex]  

Flow rate  = 8000cm³/hr

Answer:

C

Explanation:

Balanced forces cancel each other out so they do not change the object's motion

Answer:

So waves are everywhere. But what makes a wave a wave? What characteristics, properties, or behaviors are shared by the phenomena that we typically characterize as being a wave? How can waves be described in a manner that allows us to understand their basic nature and qualities?

A wave can be described as a disturbance that travels through a medium from one location to another location. Consider a slinky wave as an example of a wave. When the slinky is stretched from end to end and is held at rest, it assumes a natural position known as the equilibrium or rest position. The coils of the slinky naturally assume this position, spaced equally far apart. To introduce a wave into the slinky, the first particle is displaced or moved from its equilibrium or rest position. The particle might be moved upwards or downwards, forwards or backwards; but once moved, it is returned to its original equilibrium or rest position. The act of moving the first coil of the slinky in a given direction and then returning it to its equilibrium position creates a disturbance in the slinky. We can then observe this disturbance moving through the slinky from one end to the other. If the first coil of the slinky is given a single back-and-forth vibration, then we call the observed motion of the disturbance through the slinky a slinky pulse. A pulse is a single disturbance moving through a medium from one location to another location. However, if the first coil of the slinky is continuously and periodically vibrated in a back-and-forth manner, we would observe a repeating disturbance moving within the slinky that endures over some prolonged period of time. The repeating and periodic disturbance that moves through a medium from one location to another is referred to as a wave.

Hope That Helps!!

Explanation:

Explanation:

by finding the distance between two successful crest

Answer:

the wavelength can be measured as the distance from crest to crest  or from trough to trough , the wavelength of a wave can be measured as the distance from a point on a wave to the corresponding point on the next cycle of the wave.

Explanation:

Answer:

Negatively charged, to positively charged parts

Explanation:

Electrons are negative, negative is attracted to positive.