Answer:
The evidence of matter scattering light wave in many different directions is;
D. The colors on the water's surface match the colors in the sky
Explanation:
Light scattering is used to describe the sending of a given beam of light in many directions (by tiny particles) when the light passes through a medium, due to the disruption of the bath of the light ray as it bumps into the tiny particles
Water has the nature of absorbing the red light. The light that enters the water is scattered by the tiny particles in the water such that the blue light which is the spectrum of light water allows to pass through is reflected along with the reflection of the sky and the colors of the water surface match the colors of the sky.
Answer:
C.
Explanation:
I took the quiz
What is the density of an object with a mass of 125 g and a volume of 150 mL ?
Answer:
13
Explanation:
234567877
Select the correct answer from each drop-down menu.
Researchers stationed at different areas on a mountain and in a tunnel midway through the mountain boiled water at the same time. Even though the water at every station was at the same temperature, the pot at the top of the mountain started boiling before the others. Why?
Water boils when the vapor pressure is
the atmospheric pressure. The atmospheric pressure
at the top of the mountain.
Water boils when the vapour pressure is least the atmospheric pressure.
The atmospheric pressure is equal at the top of the mountain.
What is atmospheric pressure?The air around you has weight, and it presses against everything it touches. That pressure is called atmospheric pressure, or air pressure. It is the force exerted on a surface by the air above it as gravity pulls it to Earth.
As we go up in altitude the air pressure becomes less. When the pressure decreases, it takes less energy to get the water molecules to escape the surface. So the temperature is less than it would be at sea level.
Air pressure is higher or greater at the bottom of a mountain. This is because the height of the air above that level is thicker than at the top.
Pressure is given by the equation, P=rho*g*h, where rho is the air density, g is the gravity value and h is the thickness of the air layer on top of the level where we are considering the pressure.
Therefore, as we can see, at the bottom of the mountain, the thickness h of air is greater, and so is the pressure.
Hence, water boils when the vapour pressure is least the atmospheric pressure and the atmospheric pressure is equal at the top of the mountain.
Learn more about the atmospheric pressure here:
https://brainly.com/question/11484577
#SPJ2
The photo shows wires made of pure copper, an element
What would the smallest piece of copper be?
A. Copper atom
B. Mixture of different kinds of metallic elements
C. Copper molecule
D. Compound containing two or more elements
Answer:
B
Explanation:
I hope its right. I'm pretty sure.
Answer:
Explanation:
Copper Atom
USE LETTERS FOR ANSWERS, NO NEED TO EXPLAIN
a) Substitute symbols and formulas for words.
b) Predict the products. If no reaction occurs, write “NR” after the --> sign. c) Include abbreviations for the physical state.
d) Write out and balance the equation.
6. Mercury is poured into an aqueous solution of zinc nitrate.
7. Solutions of potassium iodide and lead (II) nitrate are mixed. The resulting lead compound is a precipitate.
thank you! :)
Answer:
Ok:
Explanation:
6a) [tex]Hg + Zn(NO_3)_2\\[/tex]
b) NR
c) [tex]Hg_{(l)} + Zn(NO_3)_2 {(aq)}=> NR[/tex]
d) Welp, no reaction so i don't know.
7a) [tex]KI + Pb(NO_3)_2[/tex]
b) [tex]PbI_2 + KNO_3[/tex]
c) All are aqeuous except for PbI2 which is solid
d) [tex]2KI _{(aq)}+ Pb(NO_3)_2_{(aq)} => PbI_2_{(s)} + 2KNO_3_{(aq)}[/tex]
Check if that is ok or if my work has any issues :).
Help please I need it!
APE X What is happening to particles of matter while a change of state is taking place?
a. They are staying at the same speed
b. They are multiplying in number
c. They are slowing down
d. They are speeding up
Answer:
a. They are staying at the same speed
Explanation:
IF CORRECT PLSPLSPLS GIVE BRAINLIEST WOULD APPRECIATE :)
Answer:
a. They are staying at the same speed
What is chemical structure about?
Answer:
chemical structure determines the molecular geometry of ca compound by prtraying the arrangement of atoms and chemical bonds in the molecule..
Explanation:
hope this helps any <3
Which of the following elements has the strongest attraction for the electrons in a bond?
(A.) hydrogen
(B.) lithium
(C.) bromine
(D.) astatine
Answer:
A)
Explanation:
Entre todos esas materias el hidrógeno es el más fuerte
What is the charge of the nucleus ? Why ?
Answer:
A nucleus is a positive charge
Explanation:
A nucleus is made up of protons and neutrons. Protons have a positive charge and neutrons have a neutral charge.
why is magneisum a metal
Answer:
Chemical element, metallic, symbol Mg, situated in group IIa in the periodic table, atomic number: 12, atomic weight: 24,312. ... Magnesium is known for a long time as the lighter structural metal in the industry, due to it's low weight and to it's capability of forming mechanically resistant alloys.
The burning of a sample of propane generated 1 04.6 kJ of heat. All of this heat was used to heat 500.0 g of water that had an initial temperature of 20.0/C. What was the final temperature of the water?
Answer: 70.0°C
Explanation:
Quantity of heat = Mass * Specific heat * Change in temperature
Quantity of heat = 104.6 KJ
Mass = 500.0 g
Specific heat of water is 4.18 J/g°C
Change in temperature assuming final temperature is x = x - 20
Units should be in grams and joules:
104,600 = 500 * 4.18 * (x - 20)
104,600 = 2,090 * (x - 20)
x - 20 = 104,600/2,090
x = 104,600/2,090 + 20
x = 69.8
= 70.0°C
In which highlighted section of the periodic table in the diagram provided above are the elements whose atoms have 1 valence electron located?
A) a
B) b
C) c
D) d
Answer:
B.
Explanation:
You have a stock solution of HNO3 with a concentration of 4.5 x 10^-4 M. However, you need 275 ml of a 2.50 x 10^-5 M solution. How much of the stock solution will you need?
Answer:
15.28 mL
Explanation:
From the question given above, the following data were obtained:
Molarity of stock solution (M₁) = 4.5x10¯⁴ M
Volume of diluted solution (V₂) = 275 mL
Molarity of diluted solution (M₂) = 2.5×10¯⁵ M
Volume of stock solution (V₁) needed =.?
The volume of the stock solution needed can be obtained by using the dilution formula as illustrated below:
M₁V₁ = M₂V₂
4.5x10¯⁴ × V₁ = 2.5×10¯⁵ × 275
4.5x10¯⁴ × V₁ = 0.006875
Divide both side by 4.5x10¯⁴
V₁ = 0.006875 / 4.5x10¯⁴
V₁ = 15.28 mL
Therefore, the volume of the stock solution needed is 15.28 mL
The prefix "semi-" means "partly". Based on your knowledge of the properties of elements, which kind of element is most likely used to make semiconductors?
liquids
metalloids
metals
nonmetals
Answer:
metalloids
Explanation:
The kind of element most likely used to make semiconductors are the metalloids.
These elements have properties between those of metals and non-metals in that they are not truly metals and are partly non-metals.
Under certain conditions they show features of metals or non - metals. The class of these elements are the metalloids. They are used to make semiconductors which are major components of electronics.(sand) and (Sand with water) both of them are heterogeneous
mixture isn't it?
Answer:
yes true
Explanation:
both are heterogeneous
Why Do Some Things Stop While Others Keep Going?
Answer:because they run out of energy when it is transferred and to other objects, or their kinetic energy
Explanation:
A student is drinking a cup of hot chocolate as they sit by a campfire on a chilly evening. They know that the cup of hot chocolate transfers thermal energy to the surrounding air. The heated air over their cup of hot chocolate expands and rises and is replaced by cooler, denser air.
This method of energy transfer is —
Answer:
A student is drinking a cup of hot chocolate as they sit by a campfire on a chilly evening. They know that the cup of hot chocolate transfers thermal energy to the surrounding air. The heated air over their cup of hot chocolate expands and rises and is replaced by cooler, denser air.
This method of energy transfer is
Explanation:
Answer:
radiation
Explanation:
radiation is when an existing heat source spreads heat to its surroundings
What is the percent composition of Phosphorus in Li3PO3
Answer:
you will get 17.983 g of lithium for every 100 g of lithium phosphate.
Explanation:
69.7% is the percent by mass of Lithium in Li[tex]_3[/tex]PO[tex]_3[/tex]. A percent is obtained by multiplying the result by 100.
One approach to show the concentration for an element within a compound or component in a combination is as a mass percentage. The mass percentage is computed by dividing the total weight of the combination by the mass of each component and multiplying the result by 100%. The mass percent is calculated by dividing the mass that contains the compound and solute by the mass for the element or solute.
99.795g/mol = molar mass of Li[tex]_3[/tex]PO[tex]_3[/tex]
6.94g/mol = molar mass of Li
mass percentage of Li=(molar mass of Li/molar mass of Li[tex]_3[/tex]PO[tex]_3[/tex])× 100
=(6.94/99.7)× 100
=69.7%
To know more about mass percentage, here:
brainly.com/question/32197511
#SPJ6
If you discover a new element, how would you know where it should go on the periodic table
Answer:
the atomic number
Explanation:
it would be in the upper corner
Someone please answer this...
Answer:
5446.8 J
Explanation:
From the question given above, the following data were obtained:
Mass (M) = 50 g
Initial temperature (T₁) = 70 °C
Final temperature (T₂) = 192.4 °C
Specific heat capacity (C) = 0.89 J/gºC
Heat (Q) required =?
Next, we shall determine the change in the temperature. This can be obtained as follow:
Initial temperature (T₁) = 70 °C
Final temperature (T₂) = 192.4 °C
Change in temperature (ΔT) =?
ΔT = T₂ – T₁
ΔT = 192.4 – 70
ΔT = 122.4 °C
Finally, we shall determine the heat required to heat up the block of aluminum as follow:
Mass (M) = 50 g
Specific heat capacity (C) = 0.89 J/gºC
Change in temperature (ΔT) = 122.4 °C
Heat (Q) required =?
Q = MCΔT
Q = 50 × 0.89 × 122.4
Q = 5446.8 J
Thus, the heat required to heat up the block of aluminum is 5446.8 J
Carbon Monoxide is a toxic gas that is colorless and tasteless. How many moles of CO are in 1 L of the gas at STP?
28 moles
0.045 moles
22.4 moles
0.224 moles
Answer:
0.045 moles
Explanation:
Given data:
Moles of CO = ?
Volume of gas = 1 L
Temperature and pressure = standard
Solution:
The given problem will be solve by using general gas equation,
PV = nRT
P= Pressure
V = volume
n = number of moles
R = general gas constant = 0.0821 atm.L/ mol.K
T = temperature in kelvin
n = PV/RT
n = 1 atm× 1L / 0.0821 atm.L/mol.K × 273 K
n = 1 atm.L / 22.41 atm.L/mol
n = 0.045 mol
How many hydrogen atoms Is needed for C4H8 to become saturated
Answer:
2 atoms
Explanation:
Because it contain one double bond
If something is up higher it will have ________________ potential energy.
the same
more
less
Answer:
More
Explanation:
Which of the following compounds is least soluble in water?
1) Copper (II) Chloride
2) Aluminum Acetate
3) Iron (III) hydroxide
4) Potassium Sulfate
Answer:
3) iron (iii) hydroxide
Explanation:
Give two limitations of law of Constant Composition
Answer:
1.The law does not hold true if the different isotopes of the element are involved in making chemical compound.
2.The law is not applicable when elements combine in the same ratio but different compounds are formed.
what water has 97% of water
Answer:
ocean
Explanation:
because its easy