Answer:
Paraffin wax's general chemical formula is CnH2n+2, according to ChemistryViews, with n being a varying number of carbon atoms. Although the chemical composition of the wax is always carbon and hydrogen, the actual number of atoms will vary based on the exact origin of the wax.
Answer:
podi mate mairu suthu naaye
Explanation:
poda mairu suthu naaye
What is the electron configuration for N (nitrogen)?
A. 1s22s23s23p1
B. 1s21p5
C. 1s22s22p3
D. 1s22s22p23s1
Explanation:
₇N = 1s² 2s² 2p³
Group = 15period = 2atomic mass = 14Hydride of Nitrogen = Ammoniavalency = 3Therefore,
Option C is correct ✔
Decide which element probably has a boiling point most and least similar to the boiling point of aluminum.
Comparing boiling point:
gallium rubidium magnesium oxygen
most similar to aluminum
least similar to aluminum
Answer:
The boiling point of gallium would be most similar to aluminum, and the boiling point of oxygen would be least similar to aluminum.
Explanation:
The atomic number of aluminum is 13, in the periodic table, magnesium lies in a similar period as Aluminum and Gallium is also present in a similar group. Thus, it can be expected that both magnesium and gallium exhibits similar boiling points with aluminum. However, gallium is a poor non-metal just like aluminum, while magnesium is a metal. Thus, it can be said that the boiling point of aluminum is more similar to gallium.
Now of the given elements, oxygen is a gas, thus, the boiling point of oxygen would be least similar to aluminum.
8)
C(diamond) → C(graphite)
delta G° = -2.9 kJ/molrxn
Which of the following best explains why the reaction represented above is not observed to occur at
room temperature?
(A) The rate of the reaction is extremely slow because of the relatively small value of AGº for
the reaction.
(B) The entropy of the system decreases because the carbon atoms in graphite are less ordered
than those in diamond.
(C) The reaction has an extremely large activation energy due to strong three-dimensional
bonding among carbon atoms in diamond.
(D) The reaction does not occur because it is not thermodynamically favorable.
Answer: its b hope this helps.
Explanation:
someone please help me answer this i’m struggling and i will give branliest
Answer:
bottom right corner with arrows going up
Which terms describe a substance that has a low melting point and poor electrical conductivity?
(1) Metallic and lustrous
(2) Dull and brittle
(3) Brittle and lustrous
(4) Metallic and dull
What is a solute?
A material that is dissolved in another material.
O A material in which another material is dissolved.
An area of space surrounding the nucleus.
O Chemical formulas on the left side of an equation.
Which is the correctly balanced equation?
A) Cl2 + 2NaI = 2NaCl + I2
B) NaOH +HCl = NaCl + H2O2
C) 2HgO = Hg + O2
D) 2Li + H2O = 2LiOH + H2
PLS HURRY, TAKING TEST, NEED HELP NOW
Answer:
A) Cl2 + 2NaI = 2NaCl + I2
Which isomer of 1-bromo-2-tert-butylcyclohexane reacts faster when refluxed with potassium tert-butoxide?Draw the structure of the expected major product from the faster reacting compound.
Answer:
See explanation and image attached
Explanation:
The reaction of 1-bromo-2-tert-butylcyclohexane with potassium tert-butoxide is an elimination reaction that occurs by E2 mechanism.
The E2 reaction proceeds faster when the hydrogens are in an antiperiplanar position at an angle of 180 degrees.
This is only attainable in the trans isomer of 1-bromo-2-tert-butylcyclohexane. Hence trans 1-bromo-2-tert-butylcyclohexane reacts faster with potassium tert-butoxide
Justin is making a snack. He toasts a piece of bread and first peanut butter and jelly on it. Then he cut an apple into several slices and adds these to his plate. Next Justin mixes a scoop of lemonade powder into a glass of water mixes it in Dad's ice. How many chemical changes occurred in this scenario? 1 2 three or four
Answer:
2
Explanation:
Toasting bread and lemonade powder in water are chemical changes. Pb&j on bread and cutting apple are physical changes.
Answer:
b
Explanation:
What is required to cause change in matter
Answer:
Adding or removing energy from matter causes a physical change as matter moves from one state to another. For example, adding thermal energy (heat) to liquid water causes it to become steam or vapor (a gas). And removing energy from liquid water causes it to become ice (a solid). ... Most liquids contract as they freeze.
Explanation:
have a nice day
What's the electron configuration of an N-3 ion?
Question 17 options:
A)
[Ne]
B)
[Ar]
C)
[H]
D)
[He]
Answer:
A. since Nitrogen has 7 electrons and when it gains 3 electrons it will have 10 electrons. using short hand rule it is [Ne]
Argon (Ar) is an element in group 18. Argon is _____.
a gas highly reactive
a metalloid
a good conductor of heat
Answer:
c
Explanation:c
it is a good conducter
A compound is an example of pure substance
True
False
what is protein denaturation
Answer:
Denaturation is a process in which proteins or nucleic acids lose the quaternary structure, tertiary structure, and secondary structure which is present in their native state, by application of some
Explanation:
Explain how atoms organize to create larger structures?
Answer:
First of all they are super tiny particles of neutrons, electrons and protons. Then they come together to organize a structure of atom. Atoms come together to form a molecule and smaller molecules work together to form macromolecules. Thus, how they organize and form building blocks of a substance.
Hope it helps!<3
1 carbon atom mixed with 1 oxygen atom what is the formula
Answer:
carbon mono oxide CO
Explanation:
as both are in 1:1 ratio so CO is formed
Someone took the last cookie from the cookie jar last night. The last person to leave the scene is the culprit. Who was it? Highlight the guilty culprit based on the clues provided.
Help me please this is due today
What happens after condensation to cause precipitation?
A
The sun heats water on the Earth's surface.
B
Water is absorbed into the ground.
C
Clouds fill with moisture and get too heavy.
D
Excess water runs downhill.
Answer:
The answer is c, Clouds fill with moisture and get too hravy
Which reaction takes place in a nuclear fission reactor?
C+HN
2 Put He → Cm
OCO+ He-Cot 'n
o U+ nKr+Ba+3'n
Answer:
The reaction that takes place in a nuclear fission reactor is answer D.
Explanation:
Step-by-step explanation:
Nuclear fission reactions involves the process by which large atomic nuclei are bombarded with energetic particles and release of an enormous amount of nuclear energy, which mainly ends up as heat energy.
So now, consider the nuclear reaction from D, after the uranium nucleus absorbs the neutron its split into two smaller nuclei (often radioactive themselves), Krypton and Barium and releases more neutrons (or energy).
When chemists work with solid materials, we simply weigh out amounts of solid reagents and calculate mole amounts when thinking about stoichiometry. However, when we dissolve a solid (also known as a solute) in a solvent to form a solution, the solute becomes evenly distributed throughout the solution and we need to know how many moles of solute are present in a particular volume of solution.a) A solution is created by dissolving 13.5 grams of ammonium chloride in enough water to make 315 mL of solution. How many moles of ammonium chloride are present in the resulting solution?b) What is the molarity of the solution described above?c) To carry out a particular reaction, you determine that you need 0.0500 moles of ammonium chloride. What volume (mL) of the solution described above will you need to complete the reaction without any leftover NH4Cl?
Answer:
See the answers below
Explanation:
13.5 g of NH4Cl was dissolved in 315 mL of water.
Moles of NH4Cl present in the solution = mass/molar mass
Molar mass of NH4Cl = 54.49 g/mol
a) Moles of NH4Cl = 13.5/54.49
= 0.25 mole
b) Molarity of solution = moles of solute/volume of solution
moles of NH4Cl = 0.25
volume of solution = 315 mL = 0.315 L
molarity = 0.25/0.315
= 0.79 M
c) moles required = 0.0500 mole
molarity = 0.79 M
molarity = moles x volume
volume = molarity/moles
= 0.79/0.0500
= 15.8 L = 15,800 mL
Which of the following statements is true?
Electrons have a positive charge.
Protons and neutrons are found in the nucleus.
Electrons and protons are found in the nucleus.
All shells can hold up to eight electrons.
Answer:
2/ Protons and neutrons are found in the nucleus.
Explanation:
What is the degree of oxidation of a simple substance
Answer:
The oxidation state of a free element (uncombined element) is zero. For a simple (monoatomic) ion, the oxidation state is equal to the net charge on the ion. For example, Cl– has an oxidation state of -1. When present in most compounds, hydrogen has an oxidation state of +1 and oxygen an oxidation state of -2
15 points! Answer only if you can please!
1. Have you ever grabbed the handle of a hot metal pan? Why did it feel hot to you?
2. What would happen if a person who is wearing a heavy winter jacket were to place a thermometer inside the jacket next to his or her skin? What would happen if we took the same jacket, after it had been hanging in a closet, and placed a thermometer inside?
3. How do you think the transfer of thermal energy causes unpopped popcorn kernels to pop?
Answer:
1. Yes
2. it would be the same i guess
3. because it travels to popcorn kernels with its heat and makes it pop'
did i get it right?
Explanation:
A system performed 145 kJ of work on the surroundings and absorbed 105 kJ of heat from the surroundings. What is the change in energy of the system?
Answer:
250 kJ
Explanation:
Step 1: Given data
Work performed by the system (w): 145 kJ (By convention, when the system performs work on the surroundings, w > 0)Heat absorbed by the system (q): 105 kJ (By convention, when the system absorbs heat from the surroundings, q > 0)Step 2: Calculate the change in the internal energy of the system
The internal energy of a thermodynamic system is the energy contained within it. We can calculate the change in the internal energy (ΔE°) using the following expression.
ΔE° = q + w
ΔE° = 105 kJ + 145 kJ = 250 kJ
Which set of terms best defines what affects kinetic energy and potential energy, respecrively
What is the structural formula of CF2Br2
Answer:
Dibromodifluoromethane
Explanation:
its snowing RIGHT NOW yay santa!!!!
Answer:
Yay
Explanation:
could i have a heart and branliest plss
What do you have to do to break a molecule?
Answer:
Heat the molecule
Explanation:
Since most bonds require energy to form, they also give off energy when they are broken. But before most bonds break, the molecule has to be heated. Then the atoms start to move, and when they move too much, the bond breaks. Molecules that require less energy to break than they give off when broken are called fuels.
GIVE 6 GIVING AWAY 100 IN A ROW HOPE YALL ENJOY MAKE SURE TO TELL PEOPLE ABOUT MY GOOD WORK TY
Answer:
YOURE AMAZING THANK YOU THANK YOU THANK YOU
Explanation: